Step 2: Connect The Scanner - Xerox XTRAVEL-SCAN - Travel Scanner 100 User Manual

Installation

Step 2: Connect the Scanner

NOTE: The scanner does not have an external power supply. It draws its power directly from the computer
through the USB cable. If you use a USB hub with your computer, the hub must have its own power supply.
The scanner does not have an on/off switch. The scanner is ready to scan as soon as its software is finished
loading onto your computer.
After you plug in the scanner you will be prompted perform a calibration. Please have your calibration page
ready.
To connect your scanner:
1. Remove any tape from the USB cable.
2. Plug the USB cable into the USB port on the scanner then into a USB port on the computer. Check your
computer's manual for USB port locations.
If the plug does not attach easily, make sure that you are plugging it in correctly. Do not force the plug
into either connection.
3. Your computer recognizes that a scanner has been plugged into the USB port and automatically loads
the appropriate software to run the scanner.
Do not proceed until you receive a message that your computer has found the new hardware, or
updated the driver database. If your computer is running Windows XP or Windows Vista, you will see a
message similar to the one below.
10
Xerox Travel Scanner 100 User's Guide