How To Route Cables - Pioneer 507CMX - PDP - 50" Plasma Panel Operating Instructions Manual

Installation and Connections

How to route cables

Speed clamps are included with this unit for bunching
cables together. Once components are connected, follow
the following steps to route cables.
1
1
Organize cables together using the provided
speed clamps.
Insert 1 into an appropriate hole on the rear of the
unit, then snap 2 into the back of 1 to fix the clamp.
Speed clamps are designed to be difficult to undo
once in place. Please attach carefully.
To attach the speed clamps to the main unit
Use the holes marked with the & sign as needed.
Connect the speed clamps using the 4 holes marked with "‡" below, depending on the situation.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over
time and may get damaged when removed.
16
En
* As viewed from the rear of the display.
2
2
Note
Cables can be routed to the right or left.
* As viewed from the rear of the display.
Bunch separated cables together and secure them
with the provided bead bands.
Do not allow excessive stress to be placed on the
ends of cables.
PDP-507CMX
PDP-607CMX