Power Cord Connection - Pioneer 507CMX - PDP - 50" Plasma Panel Operating Instructions Manual

Power cord connection

Connect the power cord after all component connections
have been completed.
AC IN
1
1
Connect the power cord to this unit.
2
Plug the power cord into a power outlet.
CAUTION
÷ Use only the power cord provided.
÷ The wall outlet used to provide electricity to this unit should be
as close as possible to the unit and within easy reach of the
user.
In the event that it is necessary to disconnect power to the
unit, first turn off the main unit's power switch, and then
disconnect the power cord from its wall outlet.
÷ For the Plasma Display, use a three-core power cord with a
ground terminal.
Always be sure to connect the power cord to a three-pronged
grounded outlet and make sure that the cord is properly
grounded. If you use a power source converter plug, use an
outlet with a ground terminal and screw down the ground line.
NO!
Do not use a power supply voltage other than that indicated (AC
100 V to 120 V, 50 Hz/60 Hz) as this may cause fire or electric
shock.
Note
Regarding the audio cable, attach the supplied ferrite core.
Wind the audio cable (not supplied) around the ferrite core once,
and then fasten the catch.
If you do not do this, this monitor will not conform to mandatory
FCC standards.
Audio cable (not supplied)
2
Installation and Connections
Ferrite core
15
En