Download  Print this page

Connect The Power Cord To The Panel; Route Then Bundle The Power Cord And Cables - Pioneer Kuro KRP-500M Operating Instructions Manual

Flat panel display.
Hide thumbs

Advertisement

Install Your Flat Panel Display
02

2.7 Connect the Power Cord to the Panel

The final connection is the power cord. Always connect the panel's power cord to a three-pronged outlet, verifying
that the cord is properly grounded. The cord includes a noise filter that reduces electrical interference from the
wall outlet.
As long as the flat panel display is plugged in to an outlet, some power is drawn through the panel. When the flat
panel display is not going to be used for a long period, unplug the panel from the power outlet. Unplugging the
panel extends the life of the plasma as well as saves energy.
Plug the cord in to the panel but do NOT plug it in to a power outlet yet.

2.8 Route then Bundle the Power Cord and Cables

Once the flat panel display is mounted, place additional equipment in the final position(s). Lay out the power cord,
panel cables, and any other device cables in a logical pattern that works for the location. Please consider the
following points when routing cables:
• Access to a 3-prong (grounded) power outlet
• Space for the noise filter between the panel and outlet
• Placement of cables under carpets or across walking paths
A reusable cable clamp is designed to lock the bundled cables in place. Your flat panel display has a total of three
holes (60 inches: two holes) to attach cable clamps to the back of the panel. Use the cable clamps as necessary.
KRP-600M
Follow the steps below to attach a cable clamp.
1 ) Thread the clamp band through the holder and bundle the cable(s) in the cable clamp.
2 ) Push and hold the levers then insert the hook into an appropriate hole on the rear of the flat panel display.
3 ) Pull up the clamp band to lock.
2
4 ) Confirm that the cable clamp is seated firmly in the panel.
Note: Avoid pinching or creating pressure points when routing or bundling cables.
22
En
Speaker cable
1
Cable clamp
KRP-500M
Speaker cable
Rear
Front
Speaker cable

Advertisement

Chapters

Table of Contents

   Also See for Pioneer Kuro KRP-500M

   Related Manuals for Pioneer Kuro KRP-500M

This manual is also suitable for:

Kuro krp-600mKrp 500m - 50" lcd flat panel display

Comments to this Manuals

Symbols: 0
Latest comments: