Troubleshooting - Pioneer 507CMX - PDP - 50" Plasma Panel Operating Instructions Manual

Additional Information

Troubleshooting

What may at first seem to be an malfunction, may be
remedied with a quick check.
Please check to see if a warning is displayed on the
screen. If displayed, refer to the table below and check
the mode. If there is no display check to see if the
problem is listed on page 39. The problem may also be
caused by something other than this unit so please also
check the other components being used such as a video
deck. If the problem can still not be solved please consult
the dealer where this unit was purchased.
38
En
About the self diagnosis mode
Messages appear on the bottom of this unit's screen to
indicate operation or connection faults. After message
confirmation, check the condition of the unit.
ERROR MESSAGE
¶ The current input signal is
CAUTION
OUT OF RANGE
or
CAUTION
UNSUPPORTED SIGNAL
or
SIGNAL NG
¶ Turn off main power (pages
WARNING
THERMAL ALERT
¶ Is ambient temperature
SHUT DOWN
¶ Remove any objects
¶ Cooling fan has
WARNING
FAN FAILURE
SHUT DOWN
¶ An invalid operation has
ERROR
INVALID KEY ENTRY
¶ Turn off main power, wait
SHUT DOWN
REMEDY
not supported by the unit.
Check the Computer signal
compatibility table on
pages 42 to 44, and change
the computer's output
signal setting appropriately.
9 and 10).
above 40 °C?
blocking the cooling vents
on the Plasma Display.
malfunctioned.
Immediately turn off
power, remove power plug
from its outlet, and consult
a Pioneer service center or
your dealer.
been attempted. Check
input signals, connections
and other settings.
for 1 to 2 minutes, then try
turning power on again. If
problem persists, remove
power plug from its outlet
and consult a Pioneer
service center or your
dealer.