Required Tools, Wires, And Cables - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010 Hardware Manual

ERX 11.3.x Hardware Guide

Required Tools, Wires, and Cables

48
Figure 23: ERX Ports and Connectors (ERX14xx Model Shown)
Cabling your system takes only a few minutes. You need the following items and those
listed in Table 6 on page 49 for proper installation:
1/8–inch flathead screwdriver
3/8–inch wrench or 3/8–inch nut-driver
No. 2 Phillips screwdriver
Ground wires—We recommend a minimum of 10-AWG ground wire.
Copyright © 2010, Juniper Networks, Inc.