Unpacking Erx7Xx Models And Erx310 Broadband Services Routers - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010 Hardware Manual

ERX 11.3.x Hardware Guide

Unpacking ERX7xx Models and ERX310 Broadband Services Routers

22
Cut the two straps that secure the carton to the skid, open the carton from the top,
1.
and remove the box of accessories that sits on top of the router.
Unlock the four plastic clips that hold the box to the skid by squeezing them in their
2.
center and pulling out, and then lift the carton off the router.
Remove the three screws that attach each of the two L-brackets to the router.
3.
To avoid scratching the router when removing it from the skid, detach one of the
4.
L-brackets from the skid by removing the three screws. See Figure 13 on page 22.
Figure 13: Removing an L-Bracket
ERX7xx models and ERX310 routers are shipped boxed, but not attached to a skid. For
your convenience, we recommend that you unpack the router in the location where you
want to install it.
To unpack an ERX7xx model or an ERX310 router:
Open the carton from the top.
1.
Remove the box of accessories that sits on top of the system.
2.
Remove the router from the box.
3.
WARNING: Three people are required to install the router in a rack: two
to lift the system into position and one to screw it to the rack.
Copyright © 2010, Juniper Networks, Inc.