Table of Contents
Advertisement
3.Preparation for Use
Connection and Installation
Level Gauge
Check
For accurate measurement, place the Weighing Platform on as flat a surface as possible and adjust the level with the adjustable feet so the bubble in
the level gauge is in the center of the frame.
CAUTION
Make sure you place the Weighing Platform on a stable level surface and adjust the level with the adjustable feet. If the
Weighing Platform is not stable because not all the feet are on the surface, for example, there is a risk of stumbling or
inaccurate measurement.
Connection of Plugs
Adjustable feet
1. Insert the plug from the AC adapter into the DC jack on the back of the Control Box.
2. Connect the cable and the AC adapter and insert the plug on the cable into the wall outlet.
WARNING
•To avoid electric shock, do not insert or remove the plug with wet hands.
•To avoid electric shock, do not use the equipment near water.
CAUTION
•To avoid measurement error, do not measure while using equipment that generates radio waves,
such as mobile phones.
10
DC Jack for AC Adapter
Pilot Lamp
Loading the Printer Paper Roll
CAUTION
● Please change the paper roll when red lines appear along the sides of the paper.
1. Turn the equipment on by pressing the [
kg
P T
STABILIZED
MALE
cm / ft.in
FEMALE
ATHLETIC
AGE
STEP ON
% FAT
2. Remove the Paper Dispenser Cover.
3. Cut off the end of the printer paper where the
3cm
4. Insert the printer paper into the slit.
5. Insert the catches of the Paper Dispenser Cover
]
key.
"P.End" will flash in the middle of the screen.
This means that there is no printer paper.
* When you do not have any printer paper to replace
the old roll, press the [
] key. "P.End" will
disappear and you can continue measurement.
When you lift up the Paper Dispenser Cover from the
back of the Control Box, it can be easily removed.
glue is (about 3 cm) in a straight line.
Please make sure to cut off the part with the
glue because the glue may hinder the paper
feeding through the printer.
The printer paper is automatically rolled up and the
edge of the paper is cut automatically.
Please remove the cut paper.
Please make sure you insert the printer paper
straight into the slit.
into the guide holes.
* If a paper jam occurs, please refer to P. 25.
11
Hide quick links:
Advertisement
Table of Contents
