Field Controls 46400900 Manual

Designed for use on SWG Series
Power Vent Hoods for controlling oil
fired heating appliances with 120 VAC
controls.
The CK-63 control has the ability to
operate the oil burner motor (up to 1/3
HP) and the venter at the same time.
This allows for shorter post purge time.
This feature requires the burner to be
equipped with a delayed oil solenoid
valve, which is not supplied with this
kit.
I
TEMS INCLUDED IN KIT
1) Junction box with mounted pressure switch
and solid state post purge control
1) 2 Ft. Length of ¼ inch aluminum tubing
1) ¼ inch tubing connector
1) Flexible conduit connector
1) WMO-1 Blocked Vent Switch
1) Thermostat Resistor Kit
This device MUST be installed by a qualified agency* in accordance with the manufacturer's installation instructions.
The definition of a qualified agency is: any individual, firm, corporation or company which either in person or through a
representative is engaged in, and is responsible for, the installation and operation of oil appliances, who is experienced
in such work, familiar with all the precautions required, and has complied with all the requirements of the authority
having jurisdiction.
WARNING:
Read the installation instructions carefully and completely before proceeding with the installation.
All wiring shall be in accordance with the National Electrical Code and applicable local codes
2630 Airport Road, Kinston, NC 28504 • Phone: 252-522-3031 • FAX: 252-522-0214 • www.fieldcontrols.com
120 VAC SYSTEM CONTROL KIT
:
DO NOT DESTROY
THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT
Model: CK-63
.