Replacing The Dimm On The Npe-G2 - Cisco NPE-G2 - Network Processing Engine G2 Installation And Configuration Information

Installing the NPE-G1 or NPE-G2

Replacing the DIMM on the NPE-G2

To replace the DIMM on the NPE-G2, use the following instructions:
Locate the DIMM on the NPE-G2. See
Step 1
Figure 7-12
1
1
Step 2 Remove the DIMM by pressing against the DIMM latches until the DIMM releases.
Step 3 Gently remove it from the DIMM socket.
Network Processing Engine and Network Services Engine Installation and Configuration
7-24
Locating the DIMM on the NPE-G2
DIMM
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Figure 7-12.
OL-4448-12