Cisco NPE-G2 - Network Processing Engine G2 Installation And Configuration Information page 59

Installation guide

Hide thumbs Also See for NPE-G2 - Network Processing Engine G2:

Installation and configuration manual (226 pages)

Table of Contents

Chapter 7

NPE-G1 and NPE-G2 Installation and Configuration Information

Clearing Counters

Interface counters may be cleared (reset) by using the command:

clear counters GigabitEthernet 0/X (where X is 1, 2, or 3)

This will not reset the interface.

Using show Commands to Check the Installation

Use show commands to identify the hardware installed in your router, to verify the operation status, to

view interface configuration settings, and to troubleshoot your router configuration. The interfaces on

the NPE-G1 and NPE-G2 are identified by their chassis slot number and interface port number

(slot/port). The interfaces on your I/O controller are also identified by chassis slot number and interface

port number (slot/port). The chassis slot number for the I/O controller is always slot 0.

the NPE-G1, NPE-G2, the I/O controller models, their corresponding interfaces, and the interface

addressing syntax for each interface.

Table 7-1

Identifying Interface Addresses on the NPE-G1, NPE-G2, and Various I/O Controllers

Model

NPE-G1 and NPE-G2

C7200-I/O-GE+E

C7200-I/O-2FE/E

C7200-I/O-FE

C7200-I/O

C7200-I/O-FE-MII

1. Both optical and copper ports report the same syntax. For example, Gigabit Ethernet RJ-45 port 0/2 reports GigabitEthernet 0/2, as does Gigabit Ethernet

GBIC port 0/2. You can use only one port per interface, depending on the port selected using the media-type command.

2. The Product Number C7200-I/O-FE does not specify MII because both an MII and an RJ-45 receptacle are included.

3. The I/O controller with the Product Number C7200-I/O-FE-MII has a single MII Fast Ethernet receptacle only. Although still supported by Cisco, this

I/O controller with a single MII receptacle is no longer an orderable product as of May 1998.

The remainder of this section provides examples of show commands that pertain to the NPE-G1 and

NPE-G2. The output from the show commands is from the NPE-G1 or the NPE-G2.

OL-4448-12

Interface

Gigabit Ethernet (port 0/1)

Gigabit Ethernet (port 0/2)

Gigabit Ethernet (port 0/3)

Gigabit Ethernet (port GE 0)

Ethernet (port E 0)

Fast Ethernet/Ethernet (port 0)

Fast Ethernet/Ethernet (port 1)