Cisco NPE-G2 - Network Processing Engine G2 Installation And Configuration Information page 11

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Figure 7-2
1
2
3
Repeat Step 1 through Step 3 if a second power supply is installed.
Step 4
This completes the procedure for disconnecting AC-input power from a Cisco uBR7246VXR router. Go
to the
Disconnecting AC-Input Power from a Cisco uBR7225VXR Router
To disconnect AC-input power from a Cisco uBR7225VXR router, complete the following steps:
Unplug the input power cable from the power source.
Step 1
Unplug the other end of the input power cable from the power supply.
Step 2
The Cisco uBR7225VXR router power supply does not have a cable retention-clip.
Note
Disconnecting DC-Input Power from a Cisco 7200 VXR Router
To disconnect DC-input power from a Cisco 7200 VXR router, complete the following steps.
OL-4448-12
Disconnecting Power from a Cisco uBR7246VXR AC-Input Power Supply
1 2
AC-input receptacle
Power switch
Handle
"Removing the NPE or NSE-1" section on page
Network Processing Engine and Network Services Engine Installation and Configuration
Removing the Network Processing Engine
3
4 Network processing engine
5 AC-input power supply
7-16.
4
5
7-11