Cisco NPE-G2 - Network Processing Engine G2 Installation And Configuration Information page 41

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
This completes the steps for reconnecting DC-input power to a Cisco 7200 VXR router. Proceed to the
"Powering Up the Router" section on page
Reconnecting DC-Input Power to a Cisco uBR7246VXR Router
To reconnect DC-input power to a Cisco uBR7246VXR router, complete the following steps.
The color coding of the DC-input power supply leads depends on the color coding of the DC power
Note
source at your site. Typically, green or green and yellow are used for ground. Make certain that the lead
color coding you choose for the DC-input power supply matches the lead color coding used at the DC
power source.
Before completing any of the following procedures, and to prevent short-circuit or shock hazards,
Warning
ensure that power is removed from the DC circuit. To ensure that all power is OFF, locate the circuit
breaker on the panel board that services the DC circuit, switch the circuit breaker to the OFF position,
and tape the switch handle of the circuit breaker in the OFF position. Statement 322
Warning When installing the unit, the ground connection must always be made first and disconnected last.
Statement 42
At the rear of the router, check that the power switch on the power supply is in the off (O) position.
Step 1
Ensure that no current is running through the –V and +V leads. To ensure that all power is off, locate the
Step 2
circuit breaker on the panel board that services the DC circuit, switch the circuit breaker to the off
position, and tape the switch handle of the circuit breaker in the off position.
OL-4448-12
7-45.
Network Processing Engine and Network Services Engine Installation and Configuration
Installing the NPE-G1 or NPE-G2
7-41