Upgrading The Sdram Sodimms On The Npe-G1 (Optional) - Cisco NPE-G2 - Network Processing Engine G2 Installation And Configuration Information

Installing the NPE-G1 or NPE-G2

Upgrading the SDRAM SODIMMs on the NPE-G1 (Optional)

If you have purchased an SDRAM memory upgrade for the NPE-G1, replace the SDRAM SODIMMs
on the NPE-G1 using the following instructions.
Removing a SODIMM
Locate the SODIMMs on the NPE-G1.
Step 1
Figure 7-14
1
Both SODIMMs must be of the same size and type, and both SODIMM sockets must be populated.
Note
Remove the SODIMM you want to replace by pulling outward on the SODIMM spring latches with your
Step 2
thumbs.
The SODIMM springs up to allow you to easily pull it from the socket.
Network Processing Engine and Network Services Engine Installation and Configuration
7-26
Locating the SODIMMs on the NPE-G1
G I G A B I T E T H E R N E T 0 / 1 G I G A B I T E T H E R N E T 0 / 1
L I N K L I N K
E N E N
R J 4 5 R X G B I C T X R J 4 5 R X
SODIMM 2
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
G I G A B I T E T H E R N E T 0 / 1 NETWORK PROCESSING ENGINE - G1
L I N K
C P U
R E S E T
E N
G B I C T X R J 4 5 R X G B I C T X C O M PA C T F L A S H
2
SODIMM 1
2
1
S L O T
A C T I V E
POWER
ON CONSOLE AUX
OL-4448-12