Cisco NM-1A-T3 - 1port Ds3 Atm Network Module User Manual page 8

How to Configure the ATM T3/E3 Network Module
Creating a PVC
To create a PVC on the ATM interface and enter interface-ATM-VC configuration mode, use the
following command, beginning in interface configuration mode:
Command
Router(config-if)# pvc [name] vpi/vci [ilmi | qsaal]
Example:
Router(config-if)# pvc cisco 0/16 ilmi
The range of values for vpi isfrom 0 to 255. The range of values for vci is from 1 to 65535.
Once you specify a name for a PVC, you can reenter the interface-ATM-VC configuration mode by
simply entering pvc name.
Mapping a Protocol Address to a PVC
The ATM interface supports a static mapping scheme that identifies the network addresses of remote
hosts or routers. This section describes how to map a PVC to an address, which is a required task for
configuring a PVC.
To map a protocol address to a PVC, use the following command in interface-ATM-VC configuration
mode:
Command
Router(config-if-atm-vc)# protocol protocol
protocol-address [ [no] broadcast]
Example:
Router(config)# protocol ip 10.68.34.237 broadcast
If you enable or disable broadcasting directly on a PVC by using the protocol command, this
Note
broadcasting configuration will take precedence over any direct configuration made using the broadcast
command.
Cisco IOS Release 12.4(15)T
8
Configuring the Cisco NM-1A-T3/E3 Network Module
Purpose
Configures a new ATM PVC by assigning a name (optional)
and VPI/VCI values. Enters interface-ATM-VC
configuration mode. Optionally configures ILMI or QSAAL
encapsulation.
Purpose
Maps a protocol address to a PVC.