Cisco NM-1A-T3 - 1port Ds3 Atm Network Module User Manual page 14

SVCs
Creating an SVC
To create an SVC, use the following commands beginning in interface configuration mode:
SUMMARY STEPS
1.
2.
3.
DETAILED STEPS
Command
Step 1
Router(config-if)# svc [name] nsap address
Example:
Router(config-if)# svc cisco nsap
47.0091.81.000000.0040.0B0A.2501.ABC1.3333.3333.05
Step 2
Router(config-if-atm-vc)# encapsulation aal5encap
Example:
Router(config-if-atm-vc)# encapsulation aal5auto
Step 3
Router(config-if-atm-vc)# protocol protocol
protocol-address [[no] broadcast]
Example:
Router(config-if-atm-vc)# protocol ip
Once you specify a name for an SVC, you can reenter interface-ATM-VC configuration mode by
entering the svc name command. You can remove an SVC configuration by entering the no svc name
command.
For a list of AAL types and encapsulations, see the section
Type".
Cisco IOS Release 12.4(15)T
14
svc [name] nsap address
encapsulation aal5encap
protocol protocol protocol-address [[no] broadcast]
Configuring the Cisco NM-1A-T3/E3 Network Module
Purpose
Creates an SVC and specifies the destination NSAP
address.
(Optional) Configures the ATM adaptation layer
(AAL) and encapsulation type.
Maps a protocol address to an SVC.
"Configuring the AAL and Encapsulation