Cisco NM-1A-T3 - 1port Ds3 Atm Network Module User Manual page 15

Configuring the Cisco NM-1A-T3/E3 Network Module
Customizing the ATM T3/E3 Network Module
You can customize the ATM T3/E3 network module. The features you can customize have default values
that will probably suit your environment and do not need to be changed. However, you might need to
enter configuration commands, depending on the requirements for your system configuration and the
protocols you plan to route on the interface. Perform the tasks in the following sections if you need to
customize the ATM T3/E3 network module:
•
•
Configuring ATM Framing
The ATM T3/E3 network module supports different framing types when it is configured as a T3
connection or an E3 connection. To configure T3 ATM framing on the T3/E3 network module enter the
following command in interface configuration mode. The no form of this command removes T3 ATM
framing.
Command
Router(config-if)# atm framing [cbitadm | cbitplcp |
m23adm | m23plcp]
Example:
Router(config-if)# atm framing cbitadm
To configure E3 ATM framing on the ATM T3/E3 network module, use the following command in
interface configuration mode. The no form of this command removes E3 ATM framing.
G751adm framing is not supported on the ATM T3/E3 network module.
Note
Command
Router(config-if)# atm framing [g832adm | g751plcp]
Example:
Router(config-if)# atm framing g751 plcp
Configuring ATM Framing
Setting the Loopback Mode
Customizing the ATM T3/E3 Network Module
Purpose
Optional. Configures T3 ATM framing type. The default T3
ATM framing type is cbitplcp
Purpose
Optional. Configures E3 ATM framing type The default E3
ATM framing type is g832.adm.
.
Cisco IOS Release 12.4(15)T
15