Cisco NM-1A-T3 - 1port Ds3 Atm Network Module User Manual page 11

Configuring the Cisco NM-1A-T3/E3 Network Module
SVCs
To use SVCs, complete the following sections:
•
•
•
•
Configuring Communication with the ILMI
In an SVC environment, you must configure a PVC for communication with ILMI so that the router can
receive simple network management protocol (SNMP) traps and new network prefixes. The
recommended vpi and vci values for the ILMI PVC are 0 and 16, respectively. To configure ILMI
communication, use the following command in interface configuration mode:
Command
Router(config-if)# pvc [name] 0/16 ilmi
Example:
Router(config-if)# pvc cisco 0/16 ilmi
This ILMI PVC can be set up only on an ATM main interface, not on ATM subinterfaces.
Note
Once you have configured an ILMI PVC, you can optionally enable the ILMI keepalive function by using
the following command in interface configuration mode:
Command
Router(config-if)# atm ilmi-keepalive [seconds]
Example:
Router(config-if)# atm ilmi-keepalive 6
No other configuration steps are required.
ILMI address registration for receipt of SNMP traps and new network prefixes is enabled by default. The
ILMI keepalive function is disabled by default; when enabled, the default interval between keepalives is
3 seconds.
Configuring Communication with the ILMI
Configuring the PVC That Performs SVC Call Setup
Configuring the NSAP Address
Creating an SVC
Purpose
Creates an ILMI PVC on an ATM main interface.
Purpose
Enables ILMI keepalives and sets the interval between
keepalives.
Cisco IOS Release 12.4(15)T
SVCs
11