Chapter 24 Poe Commands; Power Inline Consumption (Global Configuration); Power Inline Disconnect-Method - TP-Link JetStream TL-SG3424P Cli Reference Manual

Chapter 24 PoE Commands

PoE (Power over Ethernet) technology describes a system to transmit electrical power along with
data to remote devices over standard twisted-pair cable in an Ethernet network. It is especially
useful for supplying power to IP telephones, wireless LAN access points, cameras and so on.

power inline consumption (global configuration)

Description
The power inline consumption command is used to configure the max power
the PoE switch can supply.
Syntax
power inline consumption {power limit}
Parameter
power limit —— The max power the PoE switch can supply, ranging from 1 to
320W.
Command Mode
Global Configuration Mode
Example
Configure the max power the PoE switch can supply as 160W:
TP-LINK(config)# power inline consumption 160

power inline disconnect-method

Description
The power inline disconnect-method command is used to offset the power
limit being exceeded and keep the switch system using power at a usable level.
Syntax
power inline disconnect-method {deny-next-port|deny-low-priority}
Parameter
deny-next-port —— When the supply power exceeds the power limit, the PD
linked to the next port will be disconnected.
deny-low priority —— When the supply power exceeds the power limit, the PD
linked to the port with lower priority will be disconnected.
128