Troubleshooting - Bissell PROHEAT - MANUAL 3 User Manual

T
roubleshooting
Built-in heater ready light does not illuminate
Possible cause
1. The heater switch is not turned on ( I ).
2. The power switch is not turned on ( I ).
Reduce Spray or no Spray
Possible cause
1. 2-in-1 water tank may be empty.
2. Formula tank may be empty.
3. 2-in-1 water tank may not be
seated completely.
4. Pump may have lost prime.
DirtLifter PowerBrushes do not turn
Possible cause
1. The brush belt is off or broken.
2. The unit is in the upright position.
3.
Circuit breaker may have tripped.
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
Remedies
1. Turn the heater switch on ( I ).
2. Both switches must be on ( I ) to
activate the heater ready light.
Remedies
1. Fill heavy duty bladder with hand hot
tap water.
2. Fill formula tank with BISSELL deep
cleaning formula.
3. Turn power switch off ( O ).
Remove and reseat tank.
4. Turn power switch off ( O ) and
then back on ( I ). Wait one minute,
then press spray trigger.
Remedies
1. Turn power switch off ( O ) and
unplug unit from outlet. Follow
instructions on pages 17 & 18.
2. Brushes only rotate when unit is
reclined using the detent pedal.
3.
Turn the power switch off ( O ) and
unplug from outlet. Check to see if
foreign object is caught in brush roll.
Remove object. Plug machine back into
reset circuit breaker.
19 16