Machine Care - Bissell PROHEAT - MANUAL 3 User Manual

O
peration
Hard floor cleaning continued
6. Check ReadyTools dial. It should be set on
floor cleaning.
7. Set the custom clean dial to normal clean.
8. Plug into an outlet and turn the power and
heater switches to the on ( I ) position.
9.
Slowly move the machine forward and back over
hard floor surface one time while pressing
spray trigger.
caution: Do not overwet.
10. Repeat the motion without pressing the
spray trigger, using the hard floor tool to
squeegee and suction up the dirty water.
11. Allow adequate time for floors to dry.
12. Remove hard floor tool, rinse and dry
before storing.
13. If any formula remains in the formula tank,
pour it back into the Hard Floor Solutions
bottle for use the next time.
.
14
Rinse out the formula tank.
M
aintenance and care
Machine storage
once your cleaning is complete, make sure the
2-in-1 water tank is emptied, rinsed out, and
dried before the next use. The formula tank
can remain filled and ready to go, or it can
simply be emptied back into the formula bottle
if that is more convenient.
note: Store cleaner in a protected, dry area.
Since this product uses water, it must not
be stored where there is a danger of
freezing. freezing will damage internal
components and void the warranty.

Machine care

for best results, a few simple steps can assure
your machine is well maintained after your
cleaning is complete.
1. Turn power and heater switches to the off
( o ) position. Unplug the machine and wrap
the power cord.
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
15