Reset Button; Factory Defaults Button - NETGEAR FS752TP Hardware Installation Manual

Fs752tp hardware installation guide

Hide thumbs Also See for FS752TP:

Table of Contents

FS752TP Smart Switch

Reset Button

The Smart Switch has a Reset button on the front panel to allow you to manually reboot the

switch. This action is equivalent to powering the unit off and back on. The software detects

the operation of the button and performs a full hardware reset of the CPU and switch

subsystems. The last saved configuration is loaded into the switch as it resets. To operate the

Reset button, insert a device such as a paper clip into the opening to press the recessed

button. The front-panel LEDs should extinguish and light again as the switch performs its

Power On Self Test (POST).

The Smart Switch has a Factory Defaults button on the front panel so that you can remove

the current configuration and return the device to its factory settings. To operate the Factory

Defaults button, insert a device such as a paper clip into the opening to press the recessed

button for over two seconds. The switch restores all settings to the factory default

configuration and then resets. Settings including the password, VLAN settings, and port

configurations are removed.

Physical Description

Table of Contents