Port Leds - NETGEAR FS752TP Hardware Installation Manual

LED Designation
LED Mode • Solid Green— Indicates port LEDs are in Ethernet mode.
• Solid Yellow — Indicates port LEDs are in PoE mode.

Port LEDs

10/100M Fast Ethernet Ports
Each 10/100M port has a single bicolor LED. There are two operating modes, Ethernet mode
and PoE mode for the port LED. The mode can be selected by the LED mode switch
provided near the system LEDs. The possible states and associated meaning are shown in
the tables below.
Table 1. Ethernet Mode
State
Solid Green
Blinking Green
Solid Yellow
Blinking Yellow
Off
Table 2. PoE Mode
State
Solid Green
Solid Yellow
Off
FS752TP Smart Switch
Designation
A valid 100 Mbps link is established on the port.
Packets transmission or reception occurring on the port and the link is 100
Mbps.
A valid 10 Mbps link is established on the port.
Packets transmission or reception occurring on the port and the link is
10 Mbps.
No link is established on the port.
Designation
The PoE powered device (PD) is connected and the port is supplying
power successfully.
Indicates one of the following failures resulted in stopping power to that
port:
• Short circuit on PoE power circuit.
• PoE power demand exceeds power available.
• PoE current exceeds PD's classification.
• Out of proper voltage band (44~57 VDC for 802.3af, 50~57 VDC for at).
No PoE powered device connected.
Physical Description
13