Removing An Sfp; Removing Sfp Modules - IBM 2498B24 - System Storage SAN24B-4 Switch Installation, Service And User Manual

Removing SFP modules

To remove an SFP:
1. Press and hold the cable release B , as shown in section 1 of Figure 10
2. Remove the cable from the SFP, as shown in section 2.
3. Pull the bail (wire handle) D in section 3 to release the SFP.
4. Grasping it by the bail, gently but firmly pull the SFP ( C in section 4) out of
5. Repeat this procedure for the remaining ports, as required.
B
1
E
2
Figure 10. Removing an SFP
28
SAN24B-4 Express Installation, Service, and User Guide
the port.
Attention: If the SFP you are removing does not have a bail, use a small
implement such as a screwdriver to press the release trigger beneath the port.
Non-bailed SFPs can be damaged by the removal process and are not
recommended. Refer to the interoperability matrix at the following web site:
www.ibm.com/servers/storage/support/san for a list of supported SFPs and
devices.
A
scale: 1/8" = 1"
IO
IO I
!
C
Item
A
B
D
C
3
r a ck
N : 4 i n.
f o r
I O / 6
t h 1 3
N T l e ng
T E or
m m
A T s cr ew
e 5
u m o b
xi m g t
M a nt i n
m ou
4
Description
Switch chassis
Cable release