Dell PowerConnect 2808 Getting Started Manual page 162

CLI
• SNMP
•
• IP
• IP
• IP
Welcome to Dell Easy Setup Wizard.
The Setup Wizard guides you through the initial switch configuration,
and gets you up and running as quickly as possible. You can skip the
setup wizard, and enter CLI mode to manually configure the switch.
The system will prompt you with a default answer; by pressing enter,
you accept the default. You must respond to the next question to run
the setup wizard within 60 seconds, otherwise the system will
continue with normal operation using the default system
configuration.
Would you like to enter the setup wizard (you must answer this
question within 60 seconds)? (Y/N)[Y] Y
( Dell
CLI
:
:
1
The system is not setup for SNMP management by default.
To manage the switch using SNMP (required for Dell Network Manager)
you can:
160
CLI
SNMP IP
(
[Ctrl+Z]
( )
) (Y/N) [Y] Y)
IP / (192.168.2.1/255.255.255.0)
PowerConnect 2800
Web