Pivot Maintenance - Scott GAMBLER - 2011 Manual

Enlarged version

FRONT FORK SET-UP/

NOTES

CHANGE OF FRONT FORK

For the set up of the front fork please use the fork specific manual attached to the bike.

We recommend using front forks with a travel between 180 and 200 mm (568mm fork

length), as this will not influence the geometry and alter handling of the bike.

PIVOT MAINTENANCE

The pivots and bearings on SCOTT Gambler are extremely easy to maintain.

An external treatment with a grease spray after every bike wash is all you have to do.

We do not recommend heavy grease sprays since these will leave a film on the parts

which is difficult to remove. We recommend the same for the chain also.

If you have to change the bearings you can order them included in a service kit (Scott

article number: 210126) at your local SCOTT dealer or buy them with international parts

number as shown above in the specs list in a hardware store.

In case of a change of the bearings or of the rear swingarm you should contact your

local SCOTT dealer as you need a special tool kit for disassembly and assembly.

2011 SCOTT BIKE OWNERS MANUAL