System Requirements; General System Requirements - Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - INSTALLATION GUIDE 09-22-2008 Installation Manual

System Requirements

2
The following sections contain more information:
Section 2.1, "General System Requirements," on page 23
Section 2.2, "Important Browser Settings," on page 24

2.1 General System Requirements

The following hardware and software is required to install and operate Novell
Network Access Control.
ZENworks Network Access Control System Requirements
Table 2-1
Item
Server — A dedicated server or servers for product installation
with the following minimum system requirements:
Processor
RAM
Disk space
Multiple-server installation:
MS installation — One server-class network
interface cards (NICs)
and —
ES installation —
DHCP — Two server-class network interface
cards (NICs)
Inline — Two server-class network interface cards
(NICs)
802.1X-enabled installation — One server-class
network interface cards
Single-server installation — Two server-class
network interface cards (NICs)
Open PCI slot if using HA Bypass card
CD-ROM drive
An Internet connection or a web proxy server that
allows outbound HTTPS communications from the
MS.
®
ZENworks
Minimum Recommended
Pentium 4 2 GHz Pentium 4 or
higher 2.8 GHz
2 GB 4 GB
73 GB 146 GB
10/100/1000 10/100/1000
(Intel) (Intel)
optional optional
yes yes
yes yes
System Requirements
2
®
23