Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - INSTALLATION GUIDE 09-22-2008 Installation Manual page 46

TIP: The double-equal sign (==) is part of the license key. Include it with the rest of the key.
IMPORTANT: If you use a proxy server, your license key will not validate from this window
unless you have performed
Figure 3-14
10 On the Create administrator account window, create the initial Novell ZENworks
Network Access Control administrator account. (This is not the same as the server's root
account that you created in during installation.)
10a Enter a User ID and Password. We suggest the password be at least eight characters
with a mix of numbers and letters.
10b Click Finish.
10c The final step of creating the single-server installation is to configure the default
Enforcement cluster. See the Novell ZENworks Network Access Control Users Guide for
instructions on editing Enforcement clusters.
TIP: In the case of a single-server installation, the MS and ES are on the same server and
the ES is automatically joined to a default Enforcement cluster. You can change the name
of the Enforcement cluster from the user interface. See the Novell ZENworks Network
Access Control Users Guide for instructions on editing Enforcement clusters.
Creating an Enforcement Cluster
When creating a multiple-server installation (the MS and ES are installed on different servers), you
must create the clusters before you join the ESs to the cluster.
To create (name) the Enforcement cluster:
1 Using https://, point your browser to the IP address or host name of the Novell ZENworks
Network Access Control server (for example, https://10.0.64.25).
46 Novell ZENworks Network Access Control Installation Guide
Step 7 on page
Create Administrator Account Window
45.