Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - INSTALLATION GUIDE 09-22-2008 Installation Manual page 38

4 Press [Enter]. The Installation Confirmation screen appears:.
Figure 3-2
5 On the Installation Confirmation screen, type install and select OK. The Network
Configuration for eth0 screen appears.
TIP: Use the [Tab], [spacebar], and [Enter] keys to navigate between fields and make
selections on the install screens.
6 On the Network Configuration for eth0 screen, enter the IP address of the Novell
ZENworks Network Access Control MS/ES installation, as shown in
The Netmask value is prepopulated; edit the Netmask value if necessary.
TIP: You must use static IP addresses for Novell ZENworks Network Access Control servers.
Novell ZENworks Network Access Control servers cannot receive DHCP IP addresses.
Figure 3-3
38 Novell ZENworks Network Access Control Installation Guide
Install Screen, Installation Confirmation
Install Screen, Network Configuration for eth0
Figure 3-3 on page 38.