Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - INSTALLATION GUIDE 09-22-2008 Installation Manual page 37

Install Screen, Boot Prompt
Figure 3-1
3 At the boot prompt, type one of the following:
install — This is the default option that works on most systems.
noacpi — If your system hangs shortly after install is entered, use this option which
disables the [Advanced Configuration and Power Interface (ACPI)] allowing the Novell
ZENworks Network Access Control system to use the chroot command.
nodma — If your system (such as some Compaq/HP systems) has problems using [Direct
Memory Access (DMA)] to chip memory, this option disables DMA for the IDE
subsystem.
noapic — If your system BIOS has an upgrade to fix the Advanced Programmable
Interrupt Controller (APIC)] and the system continues to hang shortly after install is
entered, use this option which disables the APIC. This tells the kernel to not make use of
any IOAPICs that may be present in the system.
withoptions — If your system has problems not listed above, use this option to
specify that No additional kernel parameters are passed to the kernel to allow greater
flexibility.
Installing Novell ZENworks Network Access Control 37