Novell ZENWORKS NETWORK ACCESS CONTROL 5.0 - INSTALLATION GUIDE 09-22-2008 Installation Manual page 42

16 The server reboots and starts Novell ZENworks Network Access Control.
17 Log in to the Novell ZENworks Network Access Control server and perform the initial
configuration as described in
Creating a Multiple-server Installation
To install the MS and ES on different servers:
1 Install the MS software:
1a Perform the steps described in
on page 36
Access Control installation type screen appears
1b Select Management server.
1c Select ok. The Installation progress screen appears
1d Wait. Installation can take a few minutes.
1e When installation is complete, remove the CD.
TIP: If the server reboots before you remove the CD, the boot prompt appears again.
Remove the CD and reboot the server to start Novell ZENworks Network Access Control.
1f The server reboots and starts Novell ZENworks Network Access Control.
2 Install the ES software:
2a Perform the steps described in
on page 36
Access Control installation type screen appears
2b Select Enforcement server.
2c Select ok. The Installation progress screen appears
2d Wait. Installation can take a few minutes.
2e When installation is complete, remove the CD.
TIP: If the server reboots before you remove the CD, the boot prompt appears again.
Remove the CD and reboot the server to start Novell ZENworks Network Access Control.
2f The server reboots and starts Novell ZENworks Network Access Control.
3 Add as many ESs as your system requires.
4 Go to
Initial Configuration
NOTE: If you already have endpoints attached to a switch when you install Novell ZENworks
Network Access Control, you must log in to each switch and send the NAC revalidate command
before the endpoint can be tested and routed properly.
42 Novell ZENworks Network Access Control Installation Guide
"Initial Configuration" on page
through Step 11 on page
through Step 11 on page
"Initial Configuration" on page
"Creating a Single-server Installation" on page
41. The Novell Novell ZENworks Network
"Creating a Single-server Installation" on page
41. The Novell Novell ZENworks Network
42.
42.
36:
(Figure 3-8 on page
(Figure 3-9 on page
36:
(Figure 3-8 on page
(Figure 3-9 on page
Step 1
41).
41).
Step 1
41).
41).