Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ZENWORKS APPLIANCE DEPLOYMENT AND ADMINISTRATION REFERENCE 10.3 16-04-2010 Deployment Manual page 24

Manually Launching the ZENworks Reporting Server Wizard
If you canceled the ZENworks Reporting Server configuration while configuring ZENworks
Appliance (in
Wizard.
1 Make sure that port 5005 is free by running the following command:
netstat -ant | grep LISTEN | grep 5005
If port 5005 is not included in the list of busy ports, continue with
If port 5005 is included in the list of busy ports, see the troubleshooting scenario
ZENworks Reporting Server Wizard fails to launch manually on a ZENworks Appliance that
has ZENworks 10 Configuration Management SP3 configured to an external Oracle database"
on page
2 On ZENworks Appliance, open a terminal and run the following commands in the order listed:
. /etc/profile
su --shell=/bin/bash -c /var/adm/zenworks/zrs-config.sh zenworks
The ZENworks Reporting Server services begin.
3 Run the following command:
/usr/share/ZRSConfiguration/setup.sh --zrs-config-only
The ZENworks Reporting Server Wizard is launched.
For more information on how to configure the ZENworks Reporting Server, see
the ZENworks Reporting Server" on page 25
Reporting Server Installation
24 ZENworks 10 Configuration Management Appliance Deployment and Administration Reference
Step 3 on page 17), you must manually launch the ZENworks Reporting Server
32.
Guide.
Step
in the ZENworks 10 Configuration Management
2.
"The
"Configuring