Configuring The Preinstalled Sles 10 Sp2 - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ZENWORKS APPLIANCE DEPLOYMENT AND ADMINISTRATION REFERENCE 10.3 16-04-2010 Deployment Manual

3.2.1 Configuring the Preinstalled SLES 10 SP2

1 On the Language page of the Configuration Wizard, select the language in which you want the
wizard to continue, then click Next.
2 On the License Agreement page, accept the End User License Agreement, then click Next.
3 On the Keyboard page, configure the keyboard layout, then click Next.
4 On the Timezone page, configure the time zone and clock settings to be used in your system,
then click Next.
5 On the Root Password page, specify the root password.
6 On the Network Configuration page, select Network Interfaces > Ethernet Network Card >
Edit, then configure the following network information for ZENworks Appliance:
Host name and server name
The server must have a static IP address or a permanently leased DHCP address.
IP address for your machine (for a static IP address)
Subnet mask (for a static IP address)
Default gateway (for a static IP address)
7 Click Finish.
The ZENworks 10 Configuration Management Wizard is displayed. This wizard might take a
few seconds to launch.
8 Continue with Section 3.2.2, "Configuring the Preinstalled ZENworks Server," on page 16.
Deploying ZENworks Appliance 15