Changing The Passphrase Of The Zenworks Reporting Server; Configuring The Zenworks Reporting Server To Export Reports; Section 2.3, "Changing The Passphrase Of The Zenworks Reporting Server; Section 2.4, "Configuring The Zenworks Reporting Server To Export Reports - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM REPORTING REFERENCE 10.3 30-03-2010 Reference Manual

To manually set the synchronization interval, do the following:
1 In ZENworks Control Center, click the Configurations tab.
2 In the Management Zone Settings panel, click Reporting Services.
3 Click Folder Sync Schedule to display the Folder Sync Schedule page.
4 Specify the refresh interval when the Custom Report folders that are created in the ZENworks
Reporting Server InfoView must synchronize with the ZENworks Control Center. By default,
the refresh interval is five minutes.
5 Click OK to save the changes.
You can also use the zman command line utility to synchronize report folders. For more information,
see "Report Commands" in the
Reference.
IMPORTANT: In ZENworks Reporting Server, if a folder has both a subfolder and a report file
with the same name, then only the object that is created first is synchronized with ZENworks
Configuration Management. Therefore, it is recommended that you do not create a report and a
report folder with the same name.
2.3 Changing the Passphrase of the ZENworks
Reporting Server
When you launch ZENworks Reporting Server InfoView through the ZENworks Control Center, the
ZENworks Primary Server automatically authenticates to the ZENworks Reporting Server by using
a passphrase and launches the ZENworks Reporting Server InfoView. This passphrase is
automatically generated and set during ZENworks Reporting Server installation. The super
administrator can change this passphrase to a new randomized value.
To change the passphrase:
1 In ZENworks Control Center, click the Configurations tab.
2 In the Management Zone Settings panel, click Reporting Services.
3 Click Reset the Passphrase of the ZENworks Reporting Server to display the Reset the
Passphrase of the ZENworks Reporting Server page.
4 Select the Yes option to change the passphrase, then click Apply.
2.4 Configuring the ZENworks Reporting Server
to Export Reports
You can configure ZENworks Reporting Server to export reports by e-mail, by setting up file
locations or an FTP server at the destination.
Review the following sections to understand the different ways in which you can export the reports:
Section 2.4.1, "Configuring the ZENworks Reporting Server to Send E-Mail Notifications to
the ZENworks Administrator," on page 18
ZENworks 10 Configuration Management Command Line Utilities
Setting Up System Reporting 17