Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 632

1 Select a card from the list of detected cards in the YaST network card configura-
2 In the Address tab, click Routing.
3 Enter the IP of the Default Gateway.
4 Click OK.
5 Click Next.
6 To activate the configuration, click Finish.
Adding Special Hardware Options
Sometimes a module of a network card needs special parameters to work correctly. To
set them with YaST, proceed as follows:
1 Select a card from the list of detected cards in the YaST network card configura-
2 In the Address tab, click Advanced > Hardware Details.
3 In Options, enter the parameters for your network card. If two cards are configured
4 Click OK.
5 Click Next.
6 To activate configuration, click Finish.
616 Deployment Guide
tion module and click Edit.
tion module and click Edit.
that use the same module, these parameters are used for both.