Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 160

3 In Sound Card Volume, test your sound configuration and make adjustments to
To change the configuration of a sound card, go to the Sound Configuration dialog,
select a displayed Card Model, and click Edit. Use Delete to remove a sound card
completely.
Click Other to customize one of the following options manually:
Volume
Use this dialog for setting the volume.
Start Sequencer
For playback of MIDI files, check this option.
Set as Primary Card
Click Set as Primary Card to adjust the sequence of your sound cards. The sound
device with index 0 is the default device used by the system and the applications.
The volume and configuration of all sound cards installed are saved when you click
Finish in the YaST sound module. The mixer settings are saved to the file /etc/
asound.conf and the ALSA configuration data is appended to the end of the files
/etc/modprobe.d/sound and /etc/sysconfig/hardware.
144 Deployment Guide
Normal setup
Adjust the output volume and play a test sound.
Advanced setup with possibility to change options
Customize all settings manually.
In this dialog, there is also a shortcut to the joystick configuration. Click Joystick
configuration and select the joystick type in the following dialog to configure a
joystick. Click Next to continue.
the volume. You should start at about ten percent to avoid damage to your hearing
or the speakers. A test sound should be audible when you click Test. If you cannot
hear anything, increase the volume. Press Next > Finish to complete the sound
configuration.