Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 127

If there are several volume groups, set the current volume group in the selection box
to the upper left. The buttons in the upper right enable creation of additional volume
groups and deletion of existing volume groups. Only volume groups that do not have
any partitions assigned can be deleted. All partitions that are assigned to a volume group
are also referred to as a physical volumes (PV).
Figure 7.3 Physical Volume Setup
To add a previously unassigned partition to the selected volume group, first click the
partition then Add Volume. At this point, the name of the volume group is entered next
to the selected partition. Assign all partitions reserved for LVM to a volume group.
Otherwise, the space on the partition remains unused. Before exiting the dialog, every
volume group must be assigned at least one physical volume. After assigning all phys-
ical volumes, click Next to proceed to the configuration of logical volumes.
Configuring Logical Volumes
After the volume group has been filled with physical volumes, define the logical volumes
the operating system should use in the next dialog. Set the current volume group in a
selection box to the upper left. Next to it, the free space in the current volume group is
shown. The list below contains all logical volumes in that volume group. All normal
Linux partitions to which a mount point is assigned, all swap partitions, and all already
Advanced Disk Setup 111