Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 153

8.4.1 Bluetooth
Configure Bluetooth devices with Hardware > Bluetooth. Click Enable Bluetooth Ser-
vices to begin configuration. Bluetooth configuration is covered in detail in Section
"Configuring Bluetooth with YaST" (page 575).
8.4.2 Infrared Device
Configure an infrared device with Hardware > Infrared Device. Click Start IrDa to
begin configuration. You can configure Port and Limit Baud Rate here. Find information
about infrared devices in Section 29.3, "Infrared Data Transmission" (page 584).
8.4.3 Graphics Card and Monitor
Configure graphics cards and monitors with Hardware > Graphics Card and Monitor.
It uses the the SaX2 interface, described in Section 8.15, "SaX2" (page 182).
8.4.4 Printer
Configure a printer with Hardware > Printer. If a printer is properly connected to the
system, it should be detected automatically. Find detailed instructions for configuring
printers with YaST in Section 20.4, "Setting Up a Printer" (page 443).
8.4.5 Hard Disk Controller
Normally, the hard disk controller of your system is configured during the installation.
If you add controllers, integrate these into the system with Hardware > Disk Controller.
You can also modify the existing configuration, but this is generally not necessary.
The dialog presents a list of detected hard disk controllers and enables assignment of
the suitable kernel module with specific parameters. Use Test Loading of Module to
check if the current settings work before they are saved permanently in the system.
System Configuration with YaST 137