Table of Contents
Advertisement
Response Er6c
Assembly Hardware Kit / Ensemble du matériel de montage
DP # / DP nº #22-10-1254
14mm / 19mm Box Wrench and Phillips Screwdriver Combination Tool
Outil combinant une clé polygonale 14 mm/19 mm et un tournevis cruciforme
(1)
3.0 mm, 4.0 mm, 5.0 mm & 6.0 mm Hex Key Set
Ensemble de clés hexagonales de 3,0 mm, 4,0 mm, 5,0 mm et 6,0 mm
Assembly Notes
•
Please read the entire Response Er6c Owner's
Model:
Er6c Assembly Hardware Kit Card
Year:
DB Fitness 2011
Manual before beginning the assembly. Review
Graphics Prepared by:
Skip Reys; sreys@diamondbackfitness.com
the package contents to ensure all listed parts are
included.
•
The assembler will require 14 mm & 18 mm box
wrenches, 6 mm, 5 mm, 4 mm & 3 mm hex
wrenches, and a Phillips screwdriver for assembly.
All required tools are included.
•
The estimated assembly time of the Response Er6c
by a person familiar with basic tool usage is forty-
five (45) to sixty (60) minutes.
•
Always inspect the unit to ensure handlebars and
steparms are tightened prior to using the unit.
(1)
Install the four (4) stabilizer feet (C-23).
Date Created:
12-Sep-10
Remove the eight (8) hex fixing bolts (C-2) and 16 washers (C-4,
C-3 & C-1) from the console mast (B) and and set aside.
While supporting the console mast (B) and the rear frame (C),
connect the lower connector of wire (B-3) with connecter (C-24).
Ensure the connections are solid.
Carefully insert rear frame (C) into the receiver of the console mast
(B) taking care not to pinch the wire harness. Align the holes in the
console mast receiver with the bolt holes of the rear frame and re-
install bolts (C-2), curved washers (C-4), flat washers (C-1) and
lock washers (C-4).
Level the unit. If viewed from above, turn the knobs clockwise to
raise the feet and counter-clockwise to lower them.
ASSEMBLY INSTRUCTIONS
B
C-4
C-2
C-1
C-3
B-3
C-24
C
1
C-23
7
Advertisement
Table of Contents
