Install Memory - JETWAY V623DMR1A User Manual

CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
Auto Detect DIMM/PCI Clk
Spread Spectrum
** Current Host/PCI Clock is 133/133 MHz **
Host/PCI Clock at Next Boot is
** Current DRAM Clock is 133MHz **
DRAM Clock at Next Boot is
+2.5V Select
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
The Design of this motherboard follows chipset and CPU vender's design
WARNING!
guideline. Any attempts to push beyond product specification are not
recommended and you are taking your own risk to damage your system or
important data.
components are able to tolerate such abnormal setting, especially CPU,
memory, hard disks, and VGA cards.

2-4 Install Memory

This motherboard provides
sites for memory expansion available from minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DDR1)
Bank 2, 3 (DDR2)
Total
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 184-Pin DDR200/DDR266 DDR SDRAM module looks like.
Miscellaneous Control
Enabled
Disabled
133/33MHz
133MHz
2.55V
F6:Optimized Defaults F7:Standard Defaults
Before over clocking, you must make sure your
two 184-pin DUAL INLINE MEMORY MODULES (DIMM)
184-Pin DIMM
DDR200/DDR266
DDR SDRAM Module
DDR200/DDR266
DDR SDRAM Module
System Memory (Max. 2.0GB)
PCS
10
Item Help
Menu Level >
F1:General Help
Total Memory
X1
64MB∼1.0GB
X1
64MB∼1.0GB
2
64MB∼2.0GB