HP ap5000 - All-in-One Point of Sale System Hardware Reference Manual page 20

6. Remove the two screws below the display screen (1) and slide the display off the system (2).
Figure 2-14
7. Route the serial cable of the new display through the center hole in the hinge area and connect
the cable to the same COM port on the I/O panel that was used for the old display.
NOTE:
VGA cable of the LCD customer display to the VGA connector on the I/O panel.
8. If you are removing but not replacing the customer display, cover the slot for the display with the
customer display cover provided with the system. Slide the top of the cover in first (1) then press
the bottom of the cover in place (2).
Figure 2-15
14 Chapter 2 Hardware Upgrades
Removing the VFD Customer Display
If you are replacing the VFD customer display with an LCD customer display, connect the
Covering the VFD Customer Display Slot
ENWW