Nilfisk-Advance ECOFLEX BR 652 Operating Manuallines

OPERATING GUIDELINES
BR 652 / 752 / 752C
re you have read and understood the User Manual
ATTENTION!
ATTENTION!
Do not use the machine before you have read and understood the User Manual
ATTENTION!
k with a clean water. The
External battery charger
er temperature must not
External battery charger
°C.
External battery charger
1a. Switch off charger by pressing the
STOP button. Unplug charger cable
from red battery plug. Reconnect
the red battery plug to the machine.
1a. Switch off charger by pressing the
5. Place the brushes or the pad-holders
under the deck. Use the appropriate
STOP button. Unplug charger cable
brushes to clean the floor.
solution flow control
from red battery plug. Reconnect
as necessary, depending
the red battery plug to the machine.
pe of cleaning to be per-
10. If necessary press the extra pressure
function switch.
If necessary press the mute func-
tionswitch for reduce the noise.
1a. Switch off charger by pressing the
STOP button. Unplug charger cable
nd of the work. Empty the
from red battery plug. Reconnect
tank with the hose. Then 15. Remove the brush by turn-
5. Place the brushes or the pad-holders
ing as indicated with
e solution tank by open-
the figure and clean them.
under the deck. Use the appropriate
eft drain tap and using the
the red battery plug to the machine.
brushes to clean the floor.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
and the vacuum system
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Nilfisk-Advance A/S Tel.: +45 43 23 40 50
Sognevej 25 Fax: +45 43 43 77 00
DK-2605 Brøndby mail.com@nilfisk-advance.com
3. Fill the EcoFlex tank with a deter-
Machine with battery charger Do not use the machine befor
gent suitable for the work to be
performed (highly concentrated
detergent).
1b. Disconnect the battery charger
cable from the electrical main.
6. Turn the ignition key to "I", then
lower the deck by pressing the Green
switch. To engage the brushes,
8. Press the detergent flow control
slightly press the pedal speed and
then release it.
switch. The number of display shows
the detergent concentration level in
the solution.
11. Push the pedal speed for starting
floor cleaning. If solution applied
flows outside the brush housing dur-
ing use, reduce the flow of solution.
Switch off the machine using the key.
13. Wash with clean water the recovery
16. Take the squeegee off and remove tank and the vacuum grid. Remove
debris. Check and clean the squeegee
and clean the debris tray.
blades.
OPERATING GUIDELINES
BR 652 / 752 / 752C
4. Install the squeegee and fasten it
Machine with battery charger
2. Fill the tank with a clean water. The
clean water temperature must not
exceed 40 °C.
1b. Disconnect the battery charger
7. Press the solution flow control
switches as necessary, depending
cable from the electrical main.
on the type of cleaning to be per-
9. Lift the EcoFlex™ lever whenever you
formed.
12. At the end of the work. Empty the
recovery tank with the hose. Then
empty the solution tank by open-
ing the left drain tap and using the
adapter and the vacuum system
14. Clean the filter: 1) Close the solu-
17. Clean the machine using a damp
6. Turn the ignition key to "I", then
cloth and where needed use a neutral
cleaning product.
lower the deck by pressing the Green
switch. To engage the brushes,
slightly press the pedal speed and
then release it.
with the handwheels, then connect
the vacuum hose to the squeegee.
3. Fill the EcoFlex tank with a deter-
gent suitable for the work to be
performed (highly concentrated
detergent).
8. Press the detergent flow control
switch. The number of display shows
the detergent concentration level in
the solution.
temporarily need a greater cleaning
power.
13. Wash with clean water the recovery
tank and the vacuum grid. Remove
and clean the debris tray.
tion tap under the machine. 2)
18. Charge the batteries: Connect the
battery charger cable from the elec-
Remove the transparent cover and
trical main.
the gasket, then remove the filter
strainer.
Do
4. Install the squeegee and fasten it
with the handwheels, then connect
the vacuum hose to the squeegee.
2. Fill the tank
9. Lift the EcoFlex™ lever whenever you
temporarily need a greater cleaning
clean wate
power.
exceed 40
14. Clean the filter: 1) Close the solu-
tion tap under the machine. 2)
Remove the transparent cover and
the gasket, then remove the filter
strainer.
19. Park the machine with the recovery
7. Press the s
tank cover open.
switches a
on the typ
formed.