Authority Key Identifier Extension Default - Red Hat CERTIFICATE SYSTEM 7.1 - ADMINISTRATOR Administrator's Manual

Defaults Reference
Table 11-1
Parameter
Enable_<n>

Authority Key Identifier Extension Default

This default populates the Authority Key Identifier extension into the certificate request.
The extension is used to identify the public key that corresponds to the private key used by
a CA to sign certificates.
For general information about this extension, see "authorityKeyIdentifier" on page 731.
This default has not parameters. If used, this extension will be included in the certificate
with the public key information.
430 Red Hat Certificate System Administrator's Guide • September 2005
Authority Info Access Extension Default Configuration Parameters (Continued)
Description
• If you selected iPAddress, the value must be a valid IP
address (IPv4 or IPv6).
IPv4 address must be in n.n.n.n format, with endmost must
be in n.n.n.n,m.m.m.m format. For example:
128.21.39.40. or 128.21.39.40,255.255.255.00.
IPv 6 (IPv6) address with netmask is separated by a comma.
FOr Example 0:0:0:0:0:0:13.1.68.3 and FF01::43;
and
0:0:0:0:0:0:13.1.68.3,FFFF:FFFF:FFFF:FFFF:
FFFF:FFFF:255.255.255.0 and
FF01::43,FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FF0
0:0000.
• If you selected OID, the value must be a unique, valid OID
specified in dot-separated numeric component notation. For
example, 1.2.3.4.55.6.5.99.
• If you selected RFC822Name, the value must be a valid
Internet mail address in the fully qualified DNS format.
• If you selected URI, the value must be a non-relative universal
resource identifier (URI) following the URL syntax and
encoding rules. That is, the name must include both a scheme
(for example, http) and a fully qualified domain name or IP
address of the host. For example,
http://ocspResponder.example.com:8000
Specifies whether or not this location is enabled. Select true to
enable, select false to disable.