Red Hat CERTIFICATE SYSTEM 7.1 - ADMINISTRATOR Administrator's Manual page 654

Cloning the Certificate Manager
Be aware of the following as you designate the serial number ranges for the certificate
and request numbers of the cloned Certificate Manager:
❍
❍
In the Network Configuration dialog, enter the port numbers for the ports through
11.
which the cloned CA will communicate with the end entities and the other subsystems
in the CS.
654 Red Hat Certificate System Administrator's Guide • September 2005
CA's serial number range—On this screen, specify the lowest serial number the
CA should assign to certificates it creates in the "Starting certificate number" field.
In the "Ending certificate number" field, specify the highest serial number
available for this CA. For both the fields, you can enter the number in decimal or
hexadecimal (0xnn).
CA's request number range—On this screen, specify the lowest request number
the CA should accept for requests that it receives in the "Starting request number"
field. In the "Ending request number" field, specify the highest request number
acceptable to be received by this CA.