Advertisement
Quick Links
Bullbar Installation Guide
Part Number: BU59-3662 & BU59-3512 & BU59-3697
ENSURE PAGE SCALING IS TURNED OFF
WHEN PRINTING. CHECK SCALE LINE ON TEMPLATE BEFORE CUTTING
Fits:
This Bullbar will take approximately 3 hours to install
Tools required are
•
Spanners and socket set.
•
Pneumatic hacksaw.
•
Screwdrivers
•
Pliers and side cutters
Dobinsons BULLBARS should be installed by a qualified installer and it is
the installer responsibility to ensure correct fitment.
Fully read and understand the instructions before beginning the installation
Dobinsons Springs and Suspension
Toyota Prado 150 Series
www.dobinsonsprings.com
Advertisement
Related Manuals for Dobinsons BU59-3662
Summary of Contents for Dobinsons BU59-3662
- Page 1 • Screwdrivers • Pliers and side cutters Dobinsons BULLBARS should be installed by a qualified installer and it is the installer responsibility to ensure correct fitment. Fully read and understand the instructions before beginning the installation Dobinsons Springs and Suspension...
- Page 2 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 3 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 4 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 5 9. Cut the bottom section of each of the side radiator shrouds to allow them to clear the top of the bullbar mounting bracket. Cut them just below the bottom tab. (Again the bumper Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 6 17. If not installing a winch skip to step 25. 18. See the Installation section of your Dobinsons 4x4 Winch manual for specific detailed fitting 14. The front lower part of the radiator shrouds instructions.
- Page 7 34. Check over all bolts to ensure they are tight. keep the bullbar in its position. 35. Using the fastening hardware supplied fit the under bar protection kit. Loosely install the under protection cross bar first to the 2 outer Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 8 For this reason Dobinsons bullbars utilise a Halogen bulb. Halogen bulbs generate a considerable amount of heat to achieve the yellow colour and this causes the air inside the fog light lens to expand and contract.
- Page 9 P A G E 1 E N S U R E P A G E S C A L I N G I S T U R N E D O F F B E F O R E P R I N T I N G . C U T O U T A L L 3 P A G E S A N D A L I G N U S I N G A L I G ME N T L I N E S D I R E C T L Y O N T O P O F E A C H O T H E R .
- Page 10 P A G E 2...
- Page 11 P A G E 3...
- Page 13 (Customers with Stainless Loop Deluxe Models Only) The top loops on your Dobinsons Stainless Loop Deluxe steel bullbar are manufactured from high quality 304 grade stainless steel. Once formed and welded it is highly polished to provide a high gloss finish. Whilst the material is a high quality stainless steel, like any other exterior polished surface, care and some maintenance is required to ensure the surface finish quality.
- Page 14 C). After polishing use a soft, clean, dry rag to clean the surface and inspect in the light for an even finish. D). Once complete clean thoroughly again with a sponge and warm water. Dobinsons Spring and Suspension www.dobinsonsprings.com...
Need help?
Do you have a question about the BU59-3662 and is the answer not in the manual?
Questions and answers