Advertisement
Quick Links
Bullbar Installation Guide
ENSURE PAGE SCALING IS TURNED TO
NONE OR OFF WHEN PRINTING
Part Number: BU19-3542, BU19-3708, BU19-3709
Fits:
Ford Ranger PX MK 2 Facelift models (Without Radar Collision System)
This Bullbar will take approximately 3.5 hours to install
Tools required are
•
Spanners and socket set.
•
Pneumatic hacksaw
•
Screwdrivers
•
Pliers and side cutters
Dobinsons BULLBARS should be installed by a qualified installer and it is
the installer responsibility to ensure correct fitment.
Fully read and understand the instructions before beginning the installation
Dobinsons Springs and Suspension
www.dobinsonsprings.com
Advertisement
Related Manuals for Dobinsons BU19-3542
Summary of Contents for Dobinsons BU19-3542
- Page 1 • Screwdrivers • Pliers and side cutters Dobinsons BULLBARS should be installed by a qualified installer and it is the installer responsibility to ensure correct fitment. Fully read and understand the instructions before beginning the installation Dobinsons Springs and Suspension...
- Page 2 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 3 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 4 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 5 5. Remove the fasteners along the inside edges 3. Remove the bolts and fixings at the top of the of the wheel arches on both sides. grill attaching the top of the grill to the vehicle. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 6 12. Remove the cross beam and discard, but keep bolts. 8. Carefully remove the bumper & grill from the vehicle. 13. Remove the inner and outer “L” shaped bumper support brackets, 4 in total. 9. Remove the inner air dam grill. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 7 19. Measure down 330mm from the top of the grill and using masking tape mark a line straight across the bumper as shown below then downward 90 degrees at each end to meet the cuts from the previous step. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 8 10 27. If not installing a winch skip to step 35 supplied for the plastic section. 28. See the Installation section of your Dobinsons 4x4 Winch manual for specific detailed fitting instructions. For a brief overview see the following steps.
- Page 9 13 Using the diagram at the end of this manual, installed earlier. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 10 For this reason Dobinsons bullbars utilise a Halogen bulb. Halogen bulbs generate a considerable amount of heat to achieve the yellow colour and this causes the air inside the fog light lens to expand and contract.
- Page 13 (Customers with Stainless Loop Deluxe Models Only) The top loops on your Dobinsons Stainless Loop Deluxe steel bullbar are manufactured from high quality 304 grade stainless steel. Once formed and welded it is highly polished to provide a high gloss finish. Whilst the material is a high quality stainless steel, like any other exterior polished surface, care and some maintenance is required to ensure the surface finish quality.
- Page 14 C). After polishing use a soft, clean, dry rag to clean the surface and inspect in the light for an even finish. D). Once complete clean thoroughly again with a sponge and warm water. Dobinsons Spring and Suspension www.dobinsonsprings.com...
Need help?
Do you have a question about the BU19-3542 and is the answer not in the manual?
Questions and answers