Advertisement
Quick Links
Bullbar Installation Guide
Part Number: BU39-3530, BU39-3682, BU39-3694
ENSURE PAGE SCALING IS TURNED OFF
WHEN PRINTING
Fits:
This Bullbar will take approximately 3.5 hours to install
Tools required are
•
Spanners and socket set.
•
Pneumatic hacksaw.
•
Screwdrivers
•
Pliers and side cutters
Dobinsons BULLBARS should be installed by a qualified installer and it is
the installer responsibility to ensure correct fitment.
Fully read and understand the instructions before beginning the installation
Dobinsons Springs and Suspension
Mazda BT50 10/2011 on
www.dobinsonsprings.com
Advertisement
Related Manuals for Dobinsons BU39-3530
Summary of Contents for Dobinsons BU39-3530
- Page 1 • Screwdrivers • Pliers and side cutters Dobinsons BULLBARS should be installed by a qualified installer and it is the installer responsibility to ensure correct fitment. Fully read and understand the instructions before beginning the installation Dobinsons Springs and Suspension...
- Page 2 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 3 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 4 7. Unplug the fog lights wiring plug (if fitted). 13. Remove the inner and outer steel lower 8. Starting from the outer edges and working bumper supports. towards the centre, gently unclip the bumper from the edges and under the headlights and remove. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 5 19. Apply a small amount of masking tape around the top/visible edge of the marked line on the 23. Using the hardware supplied install the outer bumper to protect the visible paint surface chassis support brackets as shown on page 3. when cutting. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 6 If installing driving lights to the bullbar it is easiest to install now. 28. If not installing a winch skip to step 35. 29. See the Installation section of your Dobinsons 4x4 Winch manual for specific detailed fitting instructions. For a brief overview see the following steps.
- Page 7 For this reason quality snap lock crimp connectors or by Dobinsons bullbars utilise a Halogen bulb. soldering. Ensure the connection is secure and Halogen bulbs generate a considerable is sufficiently insulated.
- Page 8 The customer may choose to seal the lens of the fog light but must not seal the rear breather. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 12 (Customers with Stainless Loop Deluxe Models Only) The top loops on your Dobinsons Stainless Loop Deluxe steel bullbar are manufactured from high quality 304 grade stainless steel. Once formed and welded it is highly polished to provide a high gloss finish. Whilst the material is a high quality stainless steel, like any other exterior polished surface, care and some maintenance is required to ensure the surface finish quality.
- Page 13 C). After polishing use a soft, clean, dry rag to clean the surface and inspect in the light for an even finish. D). Once complete clean thoroughly again with a sponge and warm water. Dobinsons Spring and Suspension www.dobinsonsprings.com...
Need help?
Do you have a question about the BU39-3530 and is the answer not in the manual?
Questions and answers