Advertisement
Quick Links
Bullbar Installation Guide
Part Number: BU59-3660 & BU59-3510
Fits:
This Bullbar will take approximately 3 hours to install
Tools required are
•
Spanners and socket set.
•
Pneumatic hacksaw.
•
Screwdrivers
•
Pliers and side cutters
Dobinsons BULLBARS should be installed by a qualified installer and it is
the installer responsibility to ensure correct fitment.
Fully read and understand the instructions before beginning the installation
Dobinsons Springs and Suspension
Toyota Hilux Vigo 2005 - 2011
www.dobinsonsprings.com
Advertisement
Related Manuals for Dobinsons BU59-3660 & BU59-3510
Summary of Contents for Dobinsons BU59-3660 & BU59-3510
- Page 1 • Screwdrivers • Pliers and side cutters Dobinsons BULLBARS should be installed by a qualified installer and it is the installer responsibility to ensure correct fitment. Fully read and understand the instructions before beginning the installation Dobinsons Springs and Suspension...
- Page 2 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 3 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 4 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 5 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 6 This is easiest done by reaching in behind the wheel arch liner and unclipping both lights plugs for easier access. 11. Unclip the wiring from the indicator/parker lights. Check that the wiring will be long Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 7 Ensure the connection is secure and 16. If not installing a winch skip to step 24. 17. See the Installation section of your Dobinsons is sufficiently insulated. 4x4 Winch manual for specific detailed fitting instructions.
- Page 8 For this reason 30. Once happy with the alignment of the bullbar Dobinsons bullbars utilise a Halogen bulb. drill 2 x 8mm pinning holes on each side of the Halogen bulbs generate a considerable...
- Page 10 (Customers with Stainless Loop Deluxe Models Only) The top loops on your Dobinsons Stainless Loop Deluxe steel bullbar are manufactured from high quality 304 grade stainless steel. Once formed and welded it is highly polished to provide a high gloss finish. Whilst the material is a high quality stainless steel, like any other exterior polished surface, care and some maintenance is required to ensure the surface finish quality.
- Page 11 C). After polishing use a soft, clean, dry rag to clean the surface and inspect in the light for an even finish. D). Once complete clean thoroughly again with a sponge and warm water. Dobinsons Spring and Suspension www.dobinsonsprings.com...