Advertisement
Quick Links
Bullbar Installation Guide
Part Number: BU59-3541 & BU59-3706 & BU59-3707
Fits:
This Bullbar will take approximately 3.5 hours to install
Tools required are
•
Spanners and socket set.
•
Screwdrivers
•
Pliers and side cutters
Dobinsons BULLBARS should be installed by a qualified installer and it is
the installer responsibility to ensure correct fitment.
Fully read and understand the instructions before beginning the installation
Dobinsons Springs and Suspension
Toyota Hilux Revo 2015 on
www.dobinsonsprings.com
Advertisement
Related Manuals for Dobinsons BU59-3541
Summary of Contents for Dobinsons BU59-3541
- Page 1 • Screwdrivers • Pliers and side cutters Dobinsons BULLBARS should be installed by a qualified installer and it is the installer responsibility to ensure correct fitment. Fully read and understand the instructions before beginning the installation Dobinsons Springs and Suspension...
- Page 2 10. Remove the front horizontal air dam and the LH and RH vertical air dam, keeping aside for re-fitment later. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 3 Use a washer on each side. Leave bolts loose for re-fitment. for now. 13. Remove the 2 outer bumper support brackets. 15. Install the bullbar bracket using the nuts, bolts and washers supplied. Use the original bolts Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 4 20 to secure the grill. 18. Re-install the air dams to the vehicle. 19. Remove the plastic screw clips from the original bumper mounts near the inner lower corners of the headlights. Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 5 31. If not installing a winch skip to step 39. indicator, this can be pulled down below the 32. See the Installation section of your Dobinsons headlight and the red wire on the right hand 4x4 Winch manual for specific detailed fitting side used, and the yellow on the left hand side instructions.
- Page 6 LH side and secure to the back side of the bash plates. For the LH side you may need to Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 7 For this reason Dobinsons bullbars utilise a Halogen bulb. Halogen bulbs generate a considerable amount of heat to achieve the yellow colour and this causes the air inside the fog light lens to expand and contract.
- Page 9 (Customers with Stainless Loop Deluxe Models Only) The top loops on your Dobinsons Stainless Loop Deluxe steel bullbar are manufactured from high quality 304 grade stainless steel. Once formed and welded it is highly polished to provide a high gloss finish. Whilst the material is a high quality stainless steel, like any other exterior polished surface, care and some maintenance is required to ensure the surface finish quality.
- Page 10 C). After polishing use a soft, clean, dry rag to clean the surface and inspect in the light for an even finish. D). Once complete clean thoroughly again with a sponge and warm water. Dobinsons Spring and Suspension www.dobinsonsprings.com...