Advertisement
Quick Links
Bullbar Installation Guide
Part Number: BU45-3505, BU45-3691, BU45-3655
Fits:
This Bullbar will take approximately 2.5 hours to install
Tools required are
•
Spanners and socket set.
•
Pneumatic hacksaw.
•
Screwdrivers
•
Pliers and side cutters
Dobinsons BULLBARS should be installed by a qualified installer and it is
the installer responsibility to ensure correct fitment.
Fully read and understand the instructions before beginning the installation
Dobinsons Springs and Suspension
Nissan Patrol GU Series 4 on
www.dobinsonsprings.com
Advertisement
Related Manuals for Dobinsons BU45-3505
Summary of Contents for Dobinsons BU45-3505
- Page 1 • Screwdrivers • Pliers and side cutters Dobinsons BULLBARS should be installed by a qualified installer and it is the installer responsibility to ensure correct fitment. Fully read and understand the instructions before beginning the installation Dobinsons Springs and Suspension...
- Page 2 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 3 Dobinsons Springs and Suspension www.dobinsonsprings.com...
- Page 4 Using the diagram at the end of this manual, 8. See the Installation section of your Dobinsons join the corresponding wires to original 4x4 Winch manual for specific detailed fitting vehicle wires located in the previous step.
- Page 5 This must allow clear fog vision. For this reason be done to prevent the bullbar moving when Dobinsons bullbars utilise a Halogen bulb. winching. Halogen bulbs generate a considerable amount of heat to achieve the yellow colour and this causes the air inside the fog light lens to expand and contract.
- Page 7 (Customers with Stainless Loop Deluxe Models Only) The top loops on your Dobinsons Stainless Loop Deluxe steel bullbar are manufactured from high quality 304 grade stainless steel. Once formed and welded it is highly polished to provide a high gloss finish. Whilst the material is a high quality stainless steel, like any other exterior polished surface, care and some maintenance is required to ensure the surface finish quality.
- Page 8 C). After polishing use a soft, clean, dry rag to clean the surface and inspect in the light for an even finish. D). Once complete clean thoroughly again with a sponge and warm water. Dobinsons Spring and Suspension www.dobinsonsprings.com...
Need help?
Do you have a question about the BU45-3505 and is the answer not in the manual?
Questions and answers